Power supply Batteries Chargers and adapters Converters and regulators. Pololu dual MC motor driver shield for Arduino, bottom view with board dimensions. Note that motor and motor power connections should not be made through a breadboard. Blue, Top Closed Add to Wish List. A logical LOW results in a slow output rise time 1.

Uploader: Kanris
Date Added: 6 May 2006
File Size: 28.39 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 83768
Price: Free* [*Free Regsitration Required]

It can supply up to almost 3 A continuous current per channel to two brushed DC motors at 5 — 28 V, and it can tolerate peak currents up to 5 A per channel for a mx33926 seconds, making this a great general-purpose motor driver for medium-sized DC motors and for differential-drive robots that use such motors.

Dual MC33926 Motor Driver Carrier

The board also includes three 2-pin 3. This motor driver carries two Freescale’s MC H-bridges. However, soldering is required for assembly of the included through-hole parts. To allow you to drive your motors with the minimal number of cables, the MC dual motor driver has seven default-overriding jumpers so you can link some input directly to VDD or to the ground for D1 inputs withjumper and parametrize your motor driver without external cables.

The control lines can be reduced to two pins per channel if PWM signals are applied directly to the two input pins with both disable pins held inactive.


Canada Robotix Denison St. You can command independantly two middle-sized DC motors, for example to differential-drive a mobile robot.

Robotic arms Robotic arms Pan Tilt.

Remote Controlled Toy Robots littlebits. This pin determines the slew rate mode for both motor driver ICs. The MC has under-voltage, over-current, and over-temperature protection. HB Motor controller and Mounting Bracket. A logical LOW results in a slow output rise time 1. This pin is used only for the SF pull-up and default-overriding jumpers in the rare case where none of those features is used, VDD can be left disconnected.

The mounting hole is intended for use with 4 screws not included. Included Hardware A pin straight breakaway male header is included with the MC dual carrier board, which kc33926 be used to connect the PCB to perfboards or breadboards.

For a single-driver version of this board, please consider the MC motor driver carrier. This means that if you push the chip close to its limit, you will see less power to the motor, but it might allow you to avoid a complete shutdown.

Pololu – Dual MC Motor Driver Carrier

Product successfully added to your shopping cart. Using the dual MC motor driver shield with a microcontroller gray connections are optional. This motor driver board ships with all of the surface-mount parts populated.

Be carefull while manipulation the MC dual motor driver as it can reach a temperature hot enough to burn you before overheating. Wide operating voltage range: A logical HIGH selects a fast output rise time 0.


Dual Motor Driver MC33926

The MC dual motor driver contains protections against under-voltage, over-current, and over-temperature, that are reported by a low state on the SF pin. Your shopping cart is empty!

For example, if D2 is used for the PWM input as is typically the caseD1 must be held low to prevent it from disabling the motor driver. Write a review Your Name: Little Step-U Motor Controller.

Pololu Dual Motor Driver Carrier (V 3A MC) in Canada Robotix

Our offices are closed on December 24th and 31st, It has a 5 — 28V operating range and can deliver almost 3A continuously 5A peak to each of its two motor channels.

Products New Products Specials! Pinout The default states of many of the MC logic input pins requires that many external connections be made to use this board. Operation from 5 — 8V reduces maximum current output the device is also protected for transients up to 40V.

Note that motor and motor power connections should not be made through a breadboard.